Create your own computer from scratch is not only fun to do, but cheaper too. You can get to choose the parts you want to use on your PC. This will give you control the balance of price and quality of the newly assembled PC.
This is an important part of the computer that you need to prepare
- Processor Cooler
- Motherboard Memory
- Graphics Cards
- Hard Drive
- CD or DVD Writer
- Floppy Drive
- Sound Card
- Computer Cases
- Power Supply
- Monitor
- Keyboard
- Mouse
- The steps in making your own PC:
Step 1
Case computer motherboard includes spacer and screws. It helps set the motherboard in the case. Install the spacer into the corner and the right side of the hole. Must match the holes on your motherboard.
If the motherboard has different jack arrangements from the case of I / O (input / output) shield, use the shield that came with the motherboard. Mounting of the sections in this case.
Now, to install the processor, raise the lever next to the CPU (processor) socket. Pin CPU is made in a way that is impossible to put the CPU into the socket only one way. Therefore, if you do it right, should easily fit.
Hold the processor down and close the lever. Before installing the CPU cooler, put the thermal compound onto the CPU (on core).
Step 2
Mount cooling the processor on the processor. Press down lightly. Heat sink clip to the processor socket. Connect the CPU cooling fan power to the motherboard fan header. This is usually labeled "CPU FAN 1".
Replace the memory module into the socket called DIMM's old. Unlock both tabs and push straight down the memory. Clips on the side of the slot should be close. Slide the motherboard to the shield I / O. Insert and tighten the screw the motherboard. Do not force it.
Brown slot nearest to the processor is intended for the AGP slot video card. Insert the video card in the slot provided equitably. Put the card into place. Make sure that your AGP video card is installed correctly.
In the corner of the motherboard, let’s see two rows of pins. Connect the cases led to the pin. This causes typically labeled. Read your motherboard manual. See who leave the label that set the pin.
Step 3
now we mount the floppy drive, CD / DVD drives and hard drives. The motherboard usually has 2 IDE channels, each 2 to support the device. If you install two IDE devices on the same cable, you will have the primary to become "master" and the other to become "slaves".
This is the same procedure for the CD / DVD drives. Find a HDD and CD drive manual for the correct jumper settings. You must do this before you screw the drive into place.
Connect the hard drive to a different channel from the CD drive. Floppy controller has a socket shorter than the IDE controller.
Make sure the IDE cable that has a red line color line with PIN1.
Finally, plug in the main ATX power cable and connect all the drives with power supply. If you have a better case cooling, you can also connect them.
Now, connect the monitor, keyboard, mouse and speakers to the back of the case. Insert the power cord into the power supply unit. Check for proper installation before the first boot.